Retrieving Diagnostic Trouble Codes
NOTE:
Intermittent failures may cause CRUISE indicator light to flicker or illuminate. Light will go out if fault no longer exists. Fault may or may not be present at time of testing. However, a corresponding Diagnostic Trouble Code (DTC) may be stored in CCM memory. DTCs are retrieved by using CRUISE indicator light.
- Test drive vehicle at a speed greater than 25 MPH. Operate cruise control. If CRUISE indicator light begins to flash while driving or cruise control will not set or operate, check for DTCs. Codes from cruise control system are retrieved through self-diagnostics Data Link Connector (DLC). DLC is located in engine compartment, mounted to rear of left front strut tower. Go to next step.
- Stop vehicle and turn ignition switch to OFF position. Turn ignition switch to ON position. Connect jumper wire between DLC terminals No. 3 (E1) and No. 11 (Tc). See Fig 1 . DTCs are displayed on CRUISE indicator light as flashes. All DTCs are 2-digit numbers. See Fig 2 . DTCs indicate current faults in system.
- If any DTCs exist, perform test(s) in order given. See DIAGNOSTIC TROUBLE CODE (DTC) INDEX table. If no DTCs exist and CRUISE indicator light begins flashing on and off every .25 seconds, system is normal. After recording DTCs, remove jumper wire and turn ignition switch to OFF position.
- If no DTCs exist, CRUISE indicator light does not flash and cruise control system malfunctions, go to SYMPTOM TESTS .
DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description |
|---|---|
| 12 | Magnetic Clutch Circuit Open Or Shorted To Ground |
| 14 | Motor Circuit Open Or Shorted To Ground |
| 21 | Vehicle Speed Sensor (VSS) Circuit Open Or Shorted To Ground |
| 23 | Speed Drops More Than 10 MPH |
| 32 | Cruise Control Functional Switches Shorted |
| 34 | Abnormal Signal From Cruise Control Functional Switches |
| 41 | Continuous Cruise Control Module (CCM) Output To Actuator |
| 42 | Low System Voltage |
| 43 | Abnormal Ignition Power Supply |