DTC 41: Continuous Cruise Control Module (CCM) Output To Actuator
- If preliminary inspection has been performed, go to next step. If preliminary inspection has not been performed, go to PRELIMINARY INSPECTION under TROUBLE SHOOTING.
- Turn ignition switch to OFF position. Clear any existing DTCs. Test drive vehicle at approximately 50 MPH. Engage cruise control and note cruise control operation for one minute. Stop vehicle and test for any DTCs. If DTC 41 resets, go to next step. If DTC 41 did not reset, problem is intermittent. See PRELIMINARY INSPECTION under TROUBLE SHOOTING.
- Replace Cruise Control Module. See CRUISE CONTROL MODULE (CCM) under REMOVAL & INSTALLATION. After repair, check cruise control system for normal operation.