LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Yaris S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Automatic Transmission) >> Shift Control System >> Control Device Removal and Installation >> Removal

Control Device Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure that parking brake is applied before removal/installation.
  1. Place the selector lever in the "N" position.
  2. Remove the center console assembly. Refer to " INSTRUMENT PANEL ASSEMBLY  "  .
  3. Disconnect the A/T device harness connector (1).
  4. Remove the key interlock cable from the control device assembly. Refer to "REMOVAL AND INSTALLATION ".
    Fig 1: Identifying A/T Device Harness Connector
    G04813170
  5. Remove the bolts (A) from the control device assembly (1).
  6. Remove exhaust front tube, center muffler and heat plates. Refer to " EXHAUST MANIFOLD  "  .
    Fig 2: Identifying Control Device Assembly Bolts
    G04813171
  7. Remove the plate (1) from the control device assembly.

    <=: Vehicle front

    Fig 3: Identifying Control Device Assembly Plate
    G04813172
  8. Remove the lock plate (1) from the control cable (2).

    <=: Vehicle front

  9. Remove the control cable (2) from the control device assembly.
    Fig 4: Identifying Lock Plate And Control Cable
    G04813173
  10. Insert flat-bladed screwdrivers at points (A) and (B) as shown, and press both tabs (E) and (F) at the front (C) and rear (D) slightly toward the center of the control device assembly to remove the control device assembly from the underside of the vehicle.

    <=: Vehicle front

    Fig 5: Identifying Control Device Assembly
    G04813174
scientia non olet · About LEMON Manuals