Adjustment of A/T Position

WARNING: This page is about a different car, the 2007 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.

Move selector lever from "P" position to "1" position. You should be able to feel the detents in each position. If the detents cannot be felt or if the position indicator is improperly aligned, the control cable needs adjustment.

CAUTION: Make sure that parking brake is applied before adjustment.

Remove the air duct assembly. Refer to " AIR CLEANER AND AIR DUCT " .
Remove the control cable nut (A) and control cable (1) and place the manual lever (2) in the "P' position.
Place selector lever in "P" position.
Hold control cable (1) at the end and pull it with a force of 9.8 N (approximately 1 kg, 2.2 lb). Release the control cable and temporarily tighten control cable nut (A).
Tighten control cable nut (A) to the specified torque.
Control cable nut: Refer to " CONTROL CABLE COMPONENTS ".

Fig 1: Identifying Control Cable Nut And Control Cable With Manual Lever

CAUTION: Secure manual lever when tightening nut.
Move selector lever from "P" to "1" position again. Make sure that selector lever moves smoothly.
Check A/T position. Refer to "CHECKING OF A/T POSITION ".
Install air duct assembly. Refer to " AIR CLEANER AND AIR DUCT " .