LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1996 >> Galant ES >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Engine Controls - System/Component Tests - 3.0L) >> Computerized Engine Controls >> Control Unit >> Ground Circuits

Ground Circuits

WARNING: This page is about a different car, the 1995 Mitsubishi Montero, 1995 Mitsubishi Diamante, 1995 Mitsubishi 3000GT, and 1995 Dodge Stealth. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Using an ohmmeter, check continuity between chassis ground and PCM ground terminals. See GROUND TERMINAL IDENTIFICATION  table. Ohmmeter should indicate zero ohms. If reading not zero ohms, check and repair open circuit between PCM connector and ground. Connect voltmeter negative lead to chassis ground. Connect positive lead to PCM ground terminals. See Figure. See GROUND TERMINAL IDENTIFICATION  table. With engine running, voltmeter should indicate less than one volt. If voltmeter reading is greater than one volt, check for open, corrosion or loose connection in ground circuit.