LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2006 >> R500 >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Mixture Formation -- R500 >> Basic Knowledge >> ME-SFI warming-up control - function - GF07.61-P-3022BK

ME-SFI warming-up control - function - GF07.61-P-3022BK

ENGINE 113.967 in MODEL 219 

ENGINE 113.964 in MODEL 164.1 up to Model Year 8 

ENGINE 113.971 in MODEL 251 up to Model Year 8 

Fig 1: ME-SFI Warming-Up Control Function Diagram
G07302064Courtesy of MERCEDES-BENZ USA
Fig 2: ME-SFI Warning-Up Enrichment Graph
G07302065Courtesy of MERCEDES-BENZ USA

After start and post-start enrichment, the fuel-air mixture is further enriched by the warming-up control as part of the fuel-air mixture precipitates on the parts of the engine which are still cold.

An additional quantity of fuel is added to the engine by the ME-SFI [ME] control unit in line with the performance map.

As soon as it is enabled, the Lambda control monitors the enrichment rate.

At close to idle operation, the enrichment rate is mainly dependent on the coolant temperature at start. At partial load, the air mass is decisive.

The exhaust gas recirculation determines the amount of exhaust gases to be recycled. As the hot exhaust gases warm up the combustion chamber, the fuel vaporization changes and the enrichment rate must be tuned to match it.

The warming-up enrichment is dependent on:

During warm-up, the ignition angles are determined from a particular performance characteristic.

  Component description for the engine electronics control unit   GF07.61-P-6000BK 
  Component description for the crankshaft position sensor   GF07.04-P-6010BK 
  Component description for the camshaft Hall sensor   GF07.04-P-6020BK 
  Component description for the coolant temperature sensor   GF07.04-P-6040BK 
  Component description for the hot film MAF sensor   GF07.07-P-6000BK 
  Component description for the accelerator pedal sensor   GF30.20-P-2010BK
  Component description for the throttle valve actuator   GF30.20-P-2020BK
  Component description for the O 2 sensor   GF07.04-P-6100BK 
  Component description for the fuel injection valves   GF07.03-P-6010BK