LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2006 >> R500 >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Throttle Control, Speed Control Systems -- R500 >> Basic Knowledge >> Accelerator pedal sensor component description - GF30.20-P-2010BK

Accelerator pedal sensor component description - GF30.20-P-2010BK

ENGINE 113.967 in MODEL 219 

ENGINE 113.964 in MODEL 164.1 up to Model Year 8 

ENGINE 113.971 in MODEL 251 up to Model Year 8 

Fig 1: Identifying Accelerator Pedal Sensor And Kick-Down Simulator
G07288911Courtesy of MERCEDES-BENZ USA

Location 

The accelerator pedal sensor is located at the top of the accelerator pedal module.

Task 

Detecting the accelerator pedal position and relaying corresponding voltage signals to the motor electronics control unit.

Shown: the internal circuit in the accelerator pedal sensor (Hall principle) 

Fig 2: Accelerator Pedal Sensor Internal Circuit (Hall Principle)
G07288912Courtesy of MERCEDES-BENZ USA

Design 

Fig 3: Design Of Accelerator Pedal Sensor
G07288913Courtesy of MERCEDES-BENZ USA

IMPORTANT Always replace complete accelerator pedal module.

Design 

The accelerator pedal sensor converts the mechanical operation input by the accelerator pedal into an electrical voltage corresponding to the accelerator pedal position.

The accelerator pedal sensor operating on the Hall principle is integrated in the pedal lever shaft and consists of a shaft with a ring magnet. This rotates in a printed circuit board with stator in the fixed Hall elements. This produces a change in the voltage.

Function 

The accelerator pedal sensor is supplied via pin 1 from the ME control unit with 5 V. Pin 3 and 6 are ground connections.

The information of the accelerator pedal position is transmitted to the motor electronics control unit in the form of two signals (pin 5 with signal 1 has maximum approximately 4.8 V and pin 4 with signal 2 maximum approximately 2.4 V).

In the accelerator pedal sensor, the supply voltage for sensor 2 is split in half.

Signal 1 ranges are defined as percentages of the supply voltage (approx. 5 V) as follows:

In the event of an error at signal 1, a switchover to signal 2 takes place and emergency mode is activated.

Kick-down detection takes place via the accelerator pedal sensor, is signals 1 and 2 fall within full load range for a certain period.

If the brake pedal is operated, only idle values will now be accepted by the accelerator pedal sensor. If required, the engine control unit generates the substitute values. The signals from the accelerator pedal sensor are rejected over this time