LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 2 Touring, 1.5 Z, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Locks System >> Front Door Latch Switch Inspection

Front Door Latch Switch Inspection

  1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 110 mm {4.33 in}. 
  2. Disconnect the negative battery cable.
  3. Remove the following parts:
    1. Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
    2. Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
    3. Front door speaker (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION .)
    4. Front door glass (See FRONT DOOR GLASS REMOVAL/INSTALLATION .)
    5. Front door module panel (See FRONT DOOR MODULE PANEL REMOVAL/INSTALLATION .)
    6. Front door key cylinder (See FRONT DOOR KEY CYLINDER REMOVAL/INSTALLATION .)
    Fig 1: Identifying Distance Between Top Of Front Door Glass To Upper Part Of Front Beltline Molding
    G06942043Courtesy of MAZDA MOTORS CORP.
  4. Press the latch in using a flathead screwdriver to inspect the latch lever condition.
    Fig 2: Pressing Latch Using Flathead Screwdriver
    G06942046Courtesy of MAZDA MOTORS CORP.
  5. Verify that the continuity is as indicated in the table.
    Fig 3: Identifying Front Door Latch Switch Circuit
    G06942047Courtesy of MAZDA MOTORS CORP.
    • If not as indicated in the table, replace the front door latch and lock actuator.
    Fig 4: Identifying Front Door Latch Switch Terminal Continuity Chart
    G06200916Courtesy of MAZDA MOTORS CORP.