LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 2 Touring, 1.5 Z, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Locks System >> Front Door Key Cylinder Removal/Installation

Front Door Key Cylinder Removal/Installation

  1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 110 mm {4.33 in}. 
  2. Disconnect the negative battery cable.
    Fig 1: Identifying Distance Between Top Of Front Door Glass To Upper Part Of Front Beltline Molding
    G06941980Courtesy of MAZDA MOTORS CORP.
  3. Remove the following parts:
    1. Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
    2. Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
    3. Front door speaker (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION .)
    4. Front door glass (See FRONT DOOR GLASS REMOVAL/INSTALLATION .)
    5. Front door module panel (See FRONT DOOR MODULE PANEL REMOVAL/INSTALLATION .)
  4. Remove the service hole cover.
    Fig 2: Identifying Service Hole Cover
    G06942024Courtesy of MAZDA MOTORS CORP.
  5. Remove the tab, then remove the door lock-link bracket. (Driver's door).
    Fig 3: Door Lock-Link Bracket And Nuts With Torque Specifications
    G06942025Courtesy of MAZDA MOTORS CORP.
  6. Remove the service hole cover.
  7. Remove the screw from the service hole.
    NOTE:
    • The screw cannot be removed because of the stopper.
    Fig 4: Identifying Service Hole Cover
    G06942026Courtesy of MAZDA MOTORS CORP.
    Fig 5: Identifying Service Hole Cover Screw
    G06942027Courtesy of MAZDA MOTORS CORP.
  8. Lift the clip in the direction of the arrow shown in illustration (1), and pull out the key rod in the direction of the arrow shown in illustration (2).
    Fig 6: Identifying Key Rod
    G06942028Courtesy of MAZDA MOTORS CORP.
  9. Press the tab on the front outer handle bracket in the direction of the arrow shown in illustration.
    Fig 7: Pressing Tab On Front Outer Handle Bracket
    G06942029Courtesy of MAZDA MOTORS CORP.
  10. Maintaining the condition in procedure 9, remove the front key cylinder.
    Fig 8: Identifying Front Key Cylinder
    G06200898Courtesy of MAZDA MOTORS CORP.
  11. Using a tape-wrapped fastener remover, press up the collar cap in the direction of the arrow shown in illustration, press aside the front door key cylinder tabs (1), and remove the collar cover from the front door key cylinder.
  12. Install in the reverse order of removal.
    Fig 9: Pressing Up Collar Cap
    G06942031Courtesy of MAZDA MOTORS CORP.