Connecting Rod - Bearing Journal Clearance: Procedure
NOTE:
The crankshaft connecting rod journals must be within specifications to check the connecting rod bearing journal clearance.
- Remove the connecting rod bearing cap.
- Position a piece of Plastigage across the bearing surface.
- Install and tighten to specifications, then remove the connecting rod bearing cap.
- Measure the Plastigage to get the connecting rod bearing journal clearance. The Plastigage should be smooth and flat. A changing width indicates a tapered or damaged connecting rod or connecting rod bearing.
- For additional information, refer to GENERAL SPECIFICATIONS for Expedition or GENERAL SPECIFICATIONS for Navigator.
- If out of specification, install new components as necessary. For the procedure, refer to ENGINE - 4.6L AND 5.4L (2V) for Expedition or ENGINE 5.4L (4V) for Navigator.
NOTE:
Do not turn the crankshaft during this step.