LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2000 >> LS 3.0 S, Standard >> Repair and Diagnosis >> Body & Frame >> Power Seats >> System Tests >> Test A: No Communication With Driver's Seat Module (DSM)

Test A: No Communication With Driver's Seat Module (DSM)

WARNING: LS is equipped with driver's and passenger's side air bags. Before testing or repairing power seat system, disable air bag system. See AIR BAG RESTRAINT SYSTEMS - LS article. For any diagnostic or service to power seats equipped with side air bags, use Air Bag Simulators (418-133). Air bag simulators must be installed to air bag floor connector, and removed prior to operating vehicle.
NOTE: After repairs are complete, ensure all component are properly installed and all harness connectors are connected properly and repeat data link diagnostic test. See DATA LINK DIAGNOSTIC TEST under SELF-DIAGNOSTIC SYSTEM in MODULE COMMUNICATIONS NETWORK - LS article.
  1. Using NGS tester, clear Driver's Door Module (DDM) DTCs. Perform DDM self-test. If NGS tester communicates with DDM, go to next step. If NGS tester does not communicate with DDM, go to TEST B: NO COMMUNICATION WITH DRIVER'S DOOR MODULE (DDM)  .
  2. Turn ignition switch to OFF position. Disconnect DSM connector C341b and C341c. Measure voltage between ground and terminal No. 10 (Orange/White wire) at DSM connector C341c. Measure voltage between ground and terminal No. 2 (Red wire) at DSM connector C341b. See Figure and Figure . If both voltages are greater than 10 volts, go to next step. If either voltage is less than 10 volts, repair open in appropriate wire(s). See WIRING DIAGRAMS  .
  3. Ensure ignition is in OFF position. Measure resistance between ground and terminal No. 3 (Black wire) at DSM connector C341b. Measure resistance between ground and terminal No. 2 (Black wire) at DSM connector C341c. If both resistances are 5 ohms or less, repair module communication concern. See MODULE COMMUNICATIONS NETWORK - LS article. If either resistance is greater than 5 ohms, repair open in appropriate Black wire.