Test B: No Communication With Driver's Door Module (DDM)
WARNING:
LS is equipped with driver's and passenger's side air bags. Before testing or repairing power seat system, disable air bag system. See AIR BAG RESTRAINT SYSTEMS - LS article. For any diagnostic or service to power seats equipped with side air bags, use Air Bag Simulators (418-133). Air bag simulators must be installed to air bag floor connector, and removed prior to operating vehicle.
NOTE:
After repairs are complete, ensure all component are properly installed and all harness connectors are connected properly and repeat data link diagnostic test. See DATA LINK DIAGNOSTIC TEST under SELF-DIAGNOSTIC SYSTEM in MODULE COMMUNICATIONS NETWORK - LS article.
- Turn ignition switch to OFF position. Disconnect DDM connector C501a. Turn ignition switch to RUN position. Measure voltage between ground and terminal No. 11 (Orange wire) at DDM connector C501a. See Figure . Measure voltage between ground and terminal No. 12 (Orange/Blue wire) at DDM connector C501a. If both voltages are greater than 10 volts, go to next step. If either voltage is less than 10 volts, repair open in appropriate wire(s). See WIRING DIAGRAMS .
- Turn ignition switch to OFF position. Measure resistance between ground and terminal No. 7 (Brown/Blue wire) at DDM connector C501a. Measure resistance between ground and terminal No. 8 (Black/Orange wire) at DDM connector C501a. If both resistances are 5 ohms or less, repair module communication concern. See MODULE COMMUNICATIONS NETWORK - LS article. If either resistances are greater than 5 ohms, repair open in appropriate wire(s). See WIRING DIAGRAMS .