LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> LS 460L >> Repair and Diagnosis >> Suspension >> Front Suspension >> Axle >> Rear Axle Hub >> On-Vehicle Inspection

On-Vehicle Inspection

  1. REMOVE REAR WHEEL 
  2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH  (See REMOVAL  )
  3. REMOVE REAR DISC  (See REMOVAL )
  4. INSPECT REAR AXLE HUB BEARING LOOSENESS 
    1. Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum: 

      0.05 mm (0.0020 in.) 

      NOTE: Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the looseness exceeds the maximum, replace the axle hub.

      Fig 1: Checking Looseness Near Center Of Axle Hub
      G04944055Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSPECT REAR AXLE HUB RUNOUT 
    1. Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

      Maximum: 

      0.05 mm (0.0020 in.) 

      NOTE: Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the runout exceeds the maximum, replace the axle hub.

      Fig 2: Checking Runout On Surface Of Axle Hub Outside Hub Bolt
      G04944056Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL REAR DISC  (See INSTALLATION )
  7. ADJUST PARKING BRAKE SHOE CLEARANCE  (See ADJUSTMENT )
  8. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH  (See INSTALLATION  )
  9. INSTALL REAR WHEEL 

    Torque: 140 N*m (1428 kgf*cm, 103 ft.*lbf)