LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2001 >> ES 300 >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System (With VSC) - Diagnosis >> Diagnostic Trouble Code Chart

Diagnostic Trouble Code Chart

NOTE: Before replacing or removing the part, turn the ignition switch OFF.
NOTE:
  • Using SST 09843-18020 or 09843-18040, connect terminals Tc and E1 of the DLC1 or terminals Tc and CG of the DLC3, and remove the short pin.
  • If no abnormality is found when inspecting parts, inspect the ECU.
  • If a malfunction code is displayed during the DTC check, check the circuit listed by code. For details of each code, refer to the diagnostic procedure linked to that DTC .
DIAGNOSTIC TROUBLE CODE INDEX

DTC No. Detection Item Trouble Area
C0278/11  Open or short circuit of ABS solenoid relay circuit
  • ABS solenoid relay
  • ABS solenoid relay circuit
C0279/12  B+ short circuit of ABS solenoid relay circuit
C0273/13 (1) Open or short circuit of ABS motor relay circuit
  • ABS motor relay
  • ABS motor relay circuit
C0274/14  B+ short circuit of ABS motor relay circuit
  • ABS motor relay
  • ABS motor relay circuit
C0226/21  Open or short circuit of ABS (& BA &TRAC & VSC) actuator solenoid circuit (SFR circuit)
  • ABS (& BA & TRAC & VSC) actuator
  • SFRR or SFRH circuit
C0236/22  Open or short circuit of ABS (& BA &TRAC & VSC) actuator solenoid circuit (SFL circuit)
  • ABS (& BA & TRAC & VSC) actuator
  • SFLR or SFLH circuit
C0246/23  Open or short circuit of ABS (& BA &TRAC & VSC) actuator solenoid circuit (SRR circuit)
  • ABS (& BA & TRAC & VSC) actuator
  • SRRR or SRRH circuit
C0256/24  Open or short circuit of ABS (& BA & TRAC & VSC) actuator solenoid circuit (SRL circuit)
  • ABS (& BA & TRAC & VSC) actuator
  • SRLR or SRLH circuit
C1225/25 (3) Open or short circuit of ABS & BA & TRAC & VSC actuator solenoid circuit (SMC1 or SMC2 circuit)
  • ABS & BA & TRAC & VSC actuator
  • SMC1 or SMC2 circuit
C1226/26 (3) Open or short circuit of ABS & BA & TRAC & VSC actuator solenoid circuit (SMV1 or SMV2 circuit)
  • ABS & BA & TRAC & VSC actuator
  • SMV1 or SMV2 circuit
C1227/27 (3) Open or short circuit of ABS & BA & TRAC & VSC actuator solenoid circuit (SRC1 or SRC2 circuit)
  • ABS & BA & TRAC & VSC actuator
  • SRC1 or SRC2 circuit
C0200/31 (1) Right front wheel speed sensor signal malfunction
  • Right front, left front, right rear and left rear speed sensor
  • Each speed sensor circuit
  • Sensor rotor
C0205/32 (1) Left front wheel speed sensor signal malfunction
C0210/33 (1) Right rear wheel speed sensor signal malfunction
C0215/34 (1) Left rear wheel speed sensor signal malfunction
C1241/41  Low battery positive voltage or abnormally high battery positive voltage
  • Battery
  • Charging system
  • Power source circuit
C1243/43 (1)(3) Malfunction in deceleration sensor (abnormal constant output)
  • Deceleration sensor
  • Wire harness for deceleration sensor system
C1244/44 (3) Open or short circuit of deceleration sensor circuit
  • Deceleration sensor
  • Deceleration sensor circuit
C1245/45 (1)(3) Malfunction in deceleration sensor
  • Deceleration sensor
  • Wire harness for deceleration sensor system
C1246/46 (2)(3) Malfunction in master cylinder pressure sensor
  • Master cylinder pressure sensor
  • Master cylinder pressure sensor circuit
C1249/49  Open circuit of stop light switch circuit Stop light switch circuit
C1251/51 (1) Pump motor is locked Open circuit of pump motor circuit ABS pump motor
ALWAYS ON (4) Malfunction in ABS (& BA & TRAC & VSC) ECU
  • Battery
  • Charging system
  • Power source circuit
  • ECU
(1) This DTC will not affect to cancel the ABS warning light by repairing the trouble area, so perform the following operations: a)  Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off. b)  Clear the DTC. See PRE-CHECK .

(2) This DTC will not affect to cancel the ABS warning light by repairing the trouble area, so perform the following operations: a)  Keep the vehicle in the stationary condition for 5 seconds or more and depress the brake pedal lightly 2 or 3 times. b)  Driving the vehicle at the vehicle speed 50 km/h (31 mph) and keep depressing the brake pedal strongly for about 3 seconds. c)  Repeat the above operation 3 times or more and check that the ABS warning light goes off. d)  Clear the DTC. See PRE-CHECK  .
(3) w/VSC only.
(4) There is a case that LEXUS hand-held tester cannot be used when the ABS warning light is always on.