NTC-1: Brake Switch Sense
Possible Causes
- Ground circuit open.
- Defective brake switch.
- Brake switch sense circuit open or shorted.
- Defective PCM.
- Turn ignition off. Disconnect brake switch connector. Inspect connector. Clean or repair connections as necessary. Turn ignition on. Using a voltmeter, measure voltage of brake switch sense circuit at brake switch White/Pink wire. If voltage is more than 10 volts, go to next step. If voltage is 10 volts or less, go to step 3.
- Connect a jumper wire between ground and brake switch connector White/Pink wire. Using scan tool, read brake switch input status. If scan tool displays brake switch released, replace brake switch. If scan tool does not display brake switch released, repair open ground circuit. After repair, perform TEST VER-4A under VERIFICATION TESTS.
- Disconnect PCM connectors. Inspect connectors. Clean or repair connections as necessary. Using an ohmmeter, measure resistance between ground and brake switch sense circuit at PCM connector C3, terminal No. 24 (White/Pink wire). If resistance is 5 ohms or more, go to next step. If resistance less than 5 ohms, repair short to ground. Perform TEST VER-4A under VERIFICATION TESTS.
- Using an ohmmeter, measure resistance of brake switch sense circuit between PCM connector C3, terminal No. 24 and brake switch (White/Pink wire). If resistance is 5 ohms or more, repair open brake switch sense circuit. If resistance is less than 5 ohms, replace PCM. After repair, perform TEST VER-4A under VERIFICATION TESTS.