Test VER-4A
NOTE:
If PCM has been replaced and correct VIN and mileage have not been programmed, a DTC will be set in ABS and air bag modules. If vehicle is equipped with a Sentry Key Immobilizer Module (SKIM), sentry key data must be updated to enable starting. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION.
- If vehicle is not equipped with a diesel engine, go to next step. If vehicle is equipped with a diesel engine, and PCM has been disconnected or replaced, battery has been disconnected, or Accelerator Pedal Position Sensor (APPS) has been disconnected or replaced, APPS calibration must be programmed into PCM (diesel only). Turn ignition on. Slowly press accelerator pedal to floor and slowly release. DO NOT attempt to adjust screws or disassemble APPS. Go to next step.
- On all engines, if vehicle is equipped with ABS or air bag, enter correct VIN and mileage in PCM. Erase DTCs in ABS and air bag modules. Inspect vehicle to ensure all engine and speed control system components are connected. Reassemble and reconnect components as necessary. Using scan tool, erase DTCs from PCM.
- Road test vehicle at a speed greater than 35 MPH. Turn S/C switch on. Press and release SET button. If S/C does not engage, repair is not complete. Check for related TSBs and return to TROUBLE SHOOTING , if necessary. If speed control engages, go to next step
- Quickly depress and release RESUME/ACCEL switch. If vehicle speed increases by 2 MPH, go to next step. If vehicle speed does not increase by 2 MPH, repair is not complete. Check for related TSBs and return to TROUBLE SHOOTING , if necessary.
- Press and hold COAST switch. Vehicle speed should decrease. If vehicle speed decreases, go to next step. If vehicle speed does not decrease, repair is not complete. Check for related TSBs and return to TROUBLE SHOOTING , if necessary.
- Using caution, depress and release brake pedal. If S/C disengages, go to next step. If S/C does not disengage, repair is not complete. Check for related TSBs and return to TROUBLE SHOOTING , if necessary.
- Bring vehicle speed to 35 MPH. Depress speed control RESUME/ACCEL switch. If vehicle resumes to previously set speed, go to next step. If vehicle does not resume to previously set speed, repair is not complete. Check for related TSBs and return to TROUBLE SHOOTING , if necessary.
- Hold down SET switch. Vehicle speed should decrease. If vehicle speed decreases, go to next step. If vehicle speed did not decrease, repair is not complete. Check for related TSBs and return to TROUBLE SHOOTING , if necessary.
- Ensure vehicle speed is more than 35 MPH and release SET switch. If vehicle sets a new speed, go to next step. If vehicle did not set a new speed, repair is not complete. Check for related TSBs and return to TROUBLE SHOOTING , if necessary.
- Depress and release CANCEL switch. If S/C disengages, go to next step. If S/C did not disengage, repair is not complete. Check for related TSBs and return to TROUBLE SHOOTING , if necessary.
- Ensure vehicle speed is greater than 35 MPH. Engage speed control. Turn S/C on/off switch to OFF position. If speed control disengages, system is operating correctly. Repair is complete. If speed control does not disengage, repair is not complete. Check for related TSBs and return to TROUBLE SHOOTING , if necessary.