LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1999 >> LHS >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Vehicle Communications System >> Symptom Id Tests >> Test 15B: Odometer No Bus Message

Test 15B: Odometer No Bus Message

NOTE: For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST VER-1  after each repair.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
  1. Disconnect appropriate module from defective circuit. Using an external ohmmeter, measure resistance between ground and appropriate terminal of BCM connector (Violet/Yellow wire), as specified in TEST 15A  . If resistance is less than 5 ohms, repair Violet/Yellow wire for short to ground. If resistance is 5 ohms or more, go to next step.
  2. Connect jumper wire between ground and Violet/Yellow wire of appropriate module. Measure resistance between ground and appropriate terminal of BCM connector (Violet/Yellow wire), as specified in TEST 15A  . If resistance is less than 5 ohms, repair open Violet/Yellow wire between BCM and appropriate module. If resistance is 5 ohms or more, replace appropriate module.