Test 14A: Bus Short To Ground
NOTE:
For connector terminal identification and wiring diagrams, see
BODY CONTROL COMPUTER - INTRODUCTION article. Perform VERIFICATION TEST VER-1
after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
- Turn ignition on. Use scan tool to erase BCM DTCs. Using scan tool, read BCM DTCs. If scan tool does not display BUS SHORT TO GROUND, go to next step. If scan tool displays BUS SHORT TO GROUND, go to step 3 .
- Monitor the odometer display while performing wiggle test on BCM harness. Inspect all BCM connectors and terminals for damage. Repair as necessary. If odometer does not display NO BUS, perform TEST 15A . If odometer displays NO BUS, replace BCM.
- If odometer does not display NO BUS, perform TEST 1A . If odometer displays NO BUS, replace BCM.