LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 1995 >> 850 Base, 4D Sedan, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - Non-Turbo >> Engine Sensors & Switches >> Throttle Position (TP) Sensor

Throttle Position (TP) Sensor

  1. Connect Breakout Box (981-3190 ) and Adapter (981-3195 ) to fuel injection ECU. See Figure . DO NOT measure resistance and voltage at ECU connector. Before disconnecting/connecting control unit connector, disconnect negative battery cable.
  2. Remove ECU cover located in right front engine compartment. Remove both fuel injection and distributor ignition ECUs located in right front of engine compartment. Press adapter into ECU base. Position adapter lead at rear of ECUs and thread through slot next to distributor ignition module.
  3. Press distributor ignition ECU into position first to avoid damage to adapter lead. Press fuel injection control unit, with adapter connected, into connector in bottom of ECU box. Connect breakout box to adapter 60-pin connector.
  4. To check TP sensor signal, connect voltmeter between breakout box terminals No. 1 and 14. Turn ignition on. Voltmeter should indicate about .6 volt in idling position and about 4.2 volts in full-load position. Turn ignition off.
  5. If signal is not present or not to specification, connect voltmeter between breakout box terminals No. 2 and 20. Turn ignition on. Voltmeter should indicate about 5 volts. Turn ignition off. To check ground, connect ohmmeter between breakout box terminals No. 14 and 20. Ohmmeter should indicate about zero ohms.
  6. If no voltage was present or ground is faulty, check wiring for short to ground or voltage. If wiring is okay, repeat test using new fuel injection ECU. If voltage supply was present and ground is okay, go to next step and TP sensor resistance.
  7. Ensure ignition is off. Measure resistance between breakout box terminals No. 14 and 2. Resistance should be about 1800-2200 ohms. Connect ohmmeter between terminals No. 14 and 1. Ohmmeter should indicate about 1000 ohms when throttle is at idle position and about 2600 ohms when throttle is at full load.
  8. If resistance is incorrect or zero, measure directly at TP sensor connector to determine if fault is in switch or wiring. Replace sensor as necessary.