LEMON Manuals: Even more car manuals for everyone
Home >> VinFast >> 2023 >> VF9 Plus >> Repair and Diagnosis >> Body & Frame >> Seats >> Front Row Seats Frames And Trim >> Repair Procedures >> Front Seat Removal And Installation

Front Seat Removal And Installation

Mobile Repair Possible:  Van only

WARNING: Explosive materials 
Failure to follow specified procedures may result in death or serious injury due to improper handling of side airbags possible.
  • Only appropriately trained persons may carry out work on pyrotechnic components or the Airbag Control Unit.
  • Perform SRS disabling procedure prior to commencing work
  • When replacing components of the SRS system, never install used or non-genuine components
  • Pyrotechnic Components must be handled and scrapped appropriately

Removal Procedure: 

The procedure for the left-hand component is identical to that for the right-hand side. 

  1. There is potential for inadvertent deployment of SRS systems during repairs if the system has not been properly disabled. Refer to AIRBAG SUPPLEMENTARY RESTRAINT SYSTEM (SRS) DISABLING AND ENABLING
    NOTE: Ensure the 2-minute wait time has been observed before proceeding to next step.
  2. Disconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION
  3. Remove front seat cushion outer belt cover trim. Refer to FRONT SEAT CUSHION OUTER BELT COVER TRIM REMOVAL AND INSTALLATION/REPLACEMENT 
    G16024469Courtesy of VINFAST, LLC
  4. Remove and discard the torque prevailing bolt.

    Replace with new only. 

    Torque - First Pass: 45 Nm 

  5. Remove the seat belt.
    G16024470Courtesy of VINFAST, LLC
  6. Unlock and disconnect 2 electrical connectors (1) under the seat.
  7. Release the wiring harness (2).
    G16024471Courtesy of VINFAST, LLC
  8. Remove both plastic covers (1) of the seat guide in the front in arrow direction.
    G16024472Courtesy of VINFAST, LLC
  9. Remove both plastic covers (1) of the seat guide in the back in arrow direction.
    G16024473Courtesy of VINFAST, LLC
  10. Slide the front seat to the rearmost position and remove the front 2 bolts (1).

    Torque: 36 Nm 

    Installation note: Use new bolts. Bolts that have previously been installed must not be reused! 

  11. Slide the front seat to the foremost position and remove the rear 2 bolts (2).

    Torque: 36 Nm 

    Installation note: Use new bolts. Bolts that have previously been installed must not be reused! 

  12. Lift the seat and carefully guide it out of the vehicle with the help of a second mechanic.

    Removal note: To avoid damage when removing the seat, hold the base with one hand and the backrest with the other. Have the assistant hold the other side in a similar way. 

Installation Procedure: 

NOTE: Safety-relevant procedure step

Failure to discard the specified component(s) may cause damage to the vehicle or vehicle components.

  1. Installation is the reverse of removal procedure, noting the following.

    All fasteners must be tightened to torque specification! 

  2. Install front seat cushion outer belt cover trim. Refer to FRONT SEAT CUSHION OUTER BELT COVER TRIM REMOVAL AND INSTALLATION/REPLACEMENT 
  3. Reconnect the 12V battery negative terminal. Refer to 12V BATTERY NEGATIVE CABLE DISCONNECTION/CONNECTION