LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> C-HR LE >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Manifold Absolute Pressure Sensor >> On-Vehicle Inspection [02/2017 - ] >> Procedure

On-Vehicle Inspection [02/2017 - ]: Procedure

  1. INSPECT VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR) 
    1. GTY761371Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Vacuum Sensor Assembly (Manifold Absolute Pressure Sensor))

      Check the terminal voltage.

      1. Disconnect the vacuum sensor assembly (manifold absolute pressure sensor) connector from the vacuum sensor assembly (manifold absolute pressure sensor).
      2. Turn the ignition switch to ON.
      3. Measure the voltage according to the value(s) in the table below.

        Standard Voltage

        Tester Connection Condition Specified Condition
        C2-3 (VC) - C2-1 (E2) Ignition switch ON 4.75 to 5.25 V
        C2-2 (PIM) - C2-1 (E2) Ignition switch ON 3.0 to 5.25 V

        If the result is not as specified, there may be an open or short in the VC or E2 circuit.

    2. Check the intake manifold pressure.
      1. Connect the Techstream to the DLC3.
      2. Turn the ignition switch to ON.
      3. Turn the Techstream on.
      4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / MAP.

        Powertrain > Engine and ECT > Data List 

        Tester Display
        MAP
      5. Read the values displayed on the Techstream.

        OK

        Equivalent to atmospheric pressure.

        HINT: 

        • Standard atmospheric pressure is 101 kPa (abs) [758 mm Hg (abs)].
        • For every 100 m (328 ft.) increase in altitude, pressure drops by 1 kPa (7.5 mm Hg). This varies by weather.
      6. While applying a vacuum of 67 kPa (abs) [503 mm Hg (abs)] to the vacuum sensor assembly (manifold absolute pressure sensor) using a vacuum pump, measure the intake manifold pressure.

        OK

        23 to 38 kPa (abs) [173 to 285 mm Hg (abs)]

        HINT: 

        If the result is not as specified, replace the vacuum sensor assembly (manifold absolute pressure sensor).