LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> 86 Base, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System (Service Information) >> Fuel Pump >> Inspection [06/2016 - ] >> Procedure

Inspection [06/2016 - ]: Procedure

  1. INSPECT FUEL PUMP ASSEMBLY 
    1. Inspect the resistance of the fuel pump assembly.
      GTY695635Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        1 - 2 20°C (68°F) 0.2 to 3.0 Ω
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Fuel Pump Assembly)

        If the result is not as specified, replace the fuel pump assembly.

    2. Inspect the operation of the fuel pump assembly.
      GTY388526Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Connect a battery's negative (-) lead to terminal 3 of the connector, and a positive (+) lead to terminal 4. Check that the fuel pump operates.
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Fuel Suction Tube Assembly with Pump and Gauge)
        NOTE:
        • These tests must be performed within 10 seconds to prevent the coil from burning out.
        • Keep the fuel pump as far away from the battery as possible.
        • Always turn on and off the voltage on the battery side, and not on the fuel pump side.