LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2010 >> Sienna LE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System (Service Information)) >> Power Steering Oil Pressure Switch >> Installation >> Installation

Power Steering Oil Pressure Switch: Installation: Installation

WARNING: This page is about a different car, the 2010 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL POWER STEERING OIL PRESSURE SWITCH 
    1. Install a new O-ring to the power steering oil pressure switch.
    2. Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.
      Fig 1: Identifying Power Steering Oil Pressure Switch & O - Ring
      GTY189173Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *a New O-Ring
    3. Using a 24 mm deep socket wrench, install the power steering oil pressure switch.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

      NOTE:
      • Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (connecting surface with pressure feed tube).
      • Be careful not to damage the O-ring when installing the power steering oil pressure switch
    4. Connect the power steering oil pressure switch connector.
  2. ADD POWER STEERING FLUID 
  3. INSPECT FOR POWER STEERING FLUID LEAK 
  4. BLEED POWER STEERING FLUID  . Refer toON-VEHICLE INSPECTION - Step 2