LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2010 >> RAV4 Base, 2.5 F, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Brake Control (Service Information)) >> Steering Angle Sensor >> Installation >> Installation

Steering Angle Sensor: Installation: Installation

WARNING: This page is about a different car, the 2010 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR 
    1. Install the spiral cable with steering angle sensor. Refer to INSTALLATION - Step 1 .
      NOTE:
      • Do not replace the spiral cable with the battery connected and the ignition switch ON.
      • Do not rotate the spiral cable with the battery connected and the ignition switch ON.
      • Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
      • Do not remove the steering angle sensor from the spiral cable.
  2. INSTALL UPPER STEERING COLUMN COVER  . Refer to INSTALLATION - Step 9
  3. INSTALL LOWER STEERING COLUMN COVER  . Refer to INSTALLATION - Step 10
  4. ADJUST SPIRAL CABLE  . Refer to INSTALLATION - Step 4
  5. INSTALL STEERING WHEEL ASSEMBLY 
    1. Install the steering wheel assembly. Refer to INSTALLATION .
  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  7. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light. Refer to SYSTEM DESCRIPTION .