LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2010 >> RAV4 Base, 2.5 F, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control (Service Information)) >> Heated Oxygen Sensor >> Installation >> Installation

Heated Oxygen Sensor: Installation: Installation

WARNING: This page is about a different car, the 2009 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) 
    1. Using SST, Install the heated oxygen sensor to the front exhaust pipe assembly.
      Fig 1: Installing Heated Oxygen Sensor To Front Exhaust Pipe Assembly
      GTY148751Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00010 

      without SST 

      Torque: 44 N*m ( 449 kgf*cm, 32 ft.*lbf) 

      with SST 

      Torque: 40 N*m ( 408 kgf*cm, 30 ft.*lbf) 

      NOTE:
      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.). Refer to PRECAUTION .
      • The "with SST" torque value is effective when SST is parallel to the torque wrench.
    2. Install the grommet to the vehicle.
    3. Connect the heated oxygen sensor connector.
      Fig 2: Locating Heated Oxygen Sensor Connector
      GTY148754Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the front floor silencer pad LH.
  2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) 
    1. Using SST, Install the heated oxygen sensor to the front exhaust pipe assembly.
      Fig 3: Installing Heated Oxygen Sensor To Front Exhaust Pipe Assembly
      GTY135954Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00010 

      without SST 

      Torque: 44 N*m ( 449 kgf*cm, 32 ft.*lbf) 

      with SST 

      Torque: 40 N*m ( 408 kgf*cm, 30 ft.*lbf) 

      NOTE:
      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.). Refer to PRECAUTION .
      • The "with SST" torque value is effective when SST is parallel to the torque wrench.
    2. Install the grommet to the vehicle.
    3. Connect the heated oxygen sensor connector.
      Fig 4: Locating Heated Oxygen Sensor Connector
      GTY149053Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the front floor silencer pad RH.
  3. INSTALL FRONT FLOOR FOOTREST LH  . Refer to INSTALLATION - Step 1
  4. INSTALL FRONT DOOR OPENING TRIM COVER LH  . Refer to INSTALLATION - Step 79
  5. INSTALL FRONT DOOR SCUFF PLATE LH  . Refer to INSTALLATION - Step 81
  6. INSTALL FRONT DOOR OPENING TRIM COVER RH  . Refer to INSTALLATION - Step 17
  7. INSTALL FRONT DOOR SCUFF PLATE RH  . Refer to INSTALLATION - Step 18