LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2010 >> RAV4 Base, 2.5 F, AWD >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Window Control System (Diagnostic Codes & Symptom Tests) >> Power Window Control System >> DTC B2312: Driver Side Door Master Switch Malfunction >> Procedure

DTC B2312: Driver Side Door Master Switch Malfunction: Procedure

  1. READ VALUE USING TECHSTREAM (MASTER SWITCH) 
    1. Using the Data List to check the function of the power window master switch.
      D-DOOR MOTOR

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D Door P/W Auto SW Driver side power window
      AUTO switch signal / ON or OFF
      ON: Driver side power window AUTO switch operates
      OFF: Driver side power window AUTO switch does not operate
      -
      D Door P/W Up SW Driver side power window
      UP switch signal / ON or OFF
      ON: Driver side power window UP switch operates
      OFF: Driver side power window UP switch does not operate
      -
      D Door P/W Down SW Driver side power window
      DOWN switch signal / ON or OFF
      ON: Driver side power window DOWN switch operates
      OFF: Driver side power window DOWN switch does not operate
      -

      OK

      ON (switch operates) appears on screen.

      HINT: 

      When the power window operates normally, the problem has been caused by irregular switch operation (for example, the power window regulator master switch was held in the same position for more than 20 seconds).

    OK → REPLACE POWER WINDOW REGULATOR MOTOR (for Driver Side) 

    NG: Go to next step 

  2. CHECK WIRE HARNESS (SWITCH INPUT POWER SUPPLY) 
    Fig 1: Identifying H2 Switch Connector Terminals
    GTY239410Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the H2 switch connector.
    2. Measure the voltage of the wire harness and connector.

      Standard voltage

      Tester Connection Specified Condition
      H2-6 (B) - H2-1 (E) 10 to 14 V

    NG → REPAIR OR REPLACE HARNESS AND CONNECTOR 

    OK: Go to next step 

  3. CHECK WIRE HARNESS (MASTER SWITCH - REGULATOR MOTOR) 
    1. Disconnect the H2 switch connector.
      Fig 2: Identifying H2 Switch Connector And H4 Motor Connector Terminals
      GTY215640Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the H4 motor connector.
    3. Measure the resistance of the wire harness side connectors.

      Standard resistance

      Tester Connection Specified Condition
      H2-8 (U) - H4-10 (UP) Below 1 Ω
      H2-5 (D) - H4-7 (DOWN) Below 1 Ω
      H2-4 (A) - H4-4 (AUTO) Below 1 Ω
      H2-3 (LED) - H4-5 (LED) Below 1 Ω

    NG → REPAIR OR REPLACE HARNESS AND CONNECTOR 

    OK: Go to next step 

  4. REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY 
    1. Temporarily replace the power window regulator master switch with a new or normally functioning one.
    2. Check for DTC.

      OK

      DTC is not output.

    NG → REPLACE POWER WINDOW REGULATOR MOTOR (for Driver Side) 

    OK → END