LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Corolla LE, 1.8 L >> Repair and Diagnosis >> Electrical >> Starter >> Starting System (2ZR-FE) >> Engine Switch >> Inspection

Engine Switch: Inspection

  1. INSPECT ENGINE SWITCH 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying Terminals Of Engine Switch Connector
      G06009645Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Switch Condition Specified Condition
      SS1 (E38-7) - GND (E38-5) Pushed Below 1 Ω
      SS2 (E38-2) - GND (E38-5) Pushed Below 1 Ω
      SS1 (E38-7) - GND (E38-5) Not pushed 10 kΩ or higher
      SS2 (E38-2) - GND (E38-5) Not pushed 10 kΩ or higher

      If the result is not as specified, replace the engine switch.

    2. Apply battery voltage between the terminals of the switch and check the illumination condition of the switch.
      Fig 2: Identifying Terminals Of Engine Switch Connector
      G06009646Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK 

      MEASUREMENT CONNECTION SPECIFIED CONDITION CHART

      Measurement Condition Specified Condition
      Battery positive (+) → SWIL (E38-11) Battery negative (-) → COM (E38-4) or GND (E38-5) Illuminates
      Battery positive (+) → INDS (E38-12) Battery negative (-) → COM (E38-4) or GND (E38-5) Illuminates
      Battery positive (+) → INDW (E38-13) Battery negative (-) → COM (E.38-4) or GND (E38-5) Illuminates
      NOTE:
      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.
      • If the voltage is too low, the indicator light will not illuminate.

      If the result is not as specified, replace the engine switch.