LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> RAV4 Base, 3.5 K, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System (2GR-FE) >> Generator >> Installation

Charging System (2GR-FE): Generator: Installation

  1. INSTALL GENERATOR ASSEMBLY 
    1. Install the generator with the 2 bolts.

      Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) 

      Fig 1: Installing Generator Into Vehicle
      G04486213Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the bolt to the cylinder block.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

      Fig 2: Installing Bolt To Cylinder Block
      G04486214Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the generator connector to the generator. (See Fig 3).
    4. Connect the generator wire with the nut.

      Torque: 9.8 N*m (100 kgf*cm, 88 in.*lbf) 

      Fig 3: Connecting Wiring Harness Connectors Terminals To Generator
      G04486215Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Install the terminal cap.
    6. Connect the 2 wire harness clamps.
      Fig 4: Installing Wire Harness Clamps
      G04486216Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FAN AND GENERATOR V BELT (See appropriate step(s) under  INSTALLATION  ) 
  3. INSTALL RADIATOR RESERVOIR TANK (See appropriate step(s) under  INSTALLATION  ) 
  4. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH (See appropriate step(s) under  INSTALLATION  ) 
  5. INSTALL ENGINE UNDER COVER REAR RH (See appropriate step(s) under  INSTALLATION  ) 
  6. INSTALL FRONT WHEEL RH 
  7. INSTALL RADIATOR ASSEMBLY 
    1. Install the radiator (see INSTALLATION ).