Rear Seat Inner Belt Assembly: Installation
- INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH
- Install the child restraint seat anchor bracket RH with the 2 bolts.
Torque: 18.1 N*m (185 kgf*cm, 13 in.*lbf)
- Install the child restraint seat anchor bracket RH with the 2 bolts.
- INSTALL REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
- Install the rear seat inner w/ center belt assembly RH with the bolt, as shown in the illustration.
Torque: 41.2 N*m (420 kgf*cm, 30 in.*lbf)
NOTE:- Do not make the anchor part run onto the protruding part of the floor panel.
- Do not disassemble the retractor.
- Check the degree of tilt when the belt begins to lock the ELR.
- Check that the belt will not lock within 15°C of tilt in all the direction but the belt will lock over 45°C of tilt when moving the installed retractor gently.
If the operation is not as specified, replace the rear seat belt assembly outer center.
- Install the rear seat belt assembly outer center with the bolt.
Torque: 41.2 N*m (420 kgf*cm, 30 in.*lbf)
- Check the ELR.NOTE: The check should be performed with the assembly installed.
- With the belt installed, check that the belt locks when it is pulled out the quickly.
If the operation is not as specified, replace the rear seat belt assembly outer center.
- With the belt installed, check that the belt locks when it is pulled out the quickly.
- Check the fastening function of the child restraint system.NOTE: The check should be performed with the assembly installed.
- When the belt is pulled out fully, the belt should automatically try to retract.
- After the belt has fully retracted, the belt should be able to pulled out and retracted again.
If the operation is not as specified, replace the rear seat belt assembly outer center.
- Install the rear seat inner w/ center belt assembly RH with the bolt, as shown in the illustration.
- INSTALL REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH
- Install the rear seat inner w/ center belt assembly RH with the bolt, as shown in the illustration.
Torque: 41.2 N*m (420 kgf*cm, 30 in.*lbf)
NOTE: Do not make the anchor part run onto the protruding part of the floor panel.
- Install the rear seat inner w/ center belt assembly RH with the bolt, as shown in the illustration.
- INSTALL REAR SEAT CUSHION ASSEMBLY
- INSTALL REAR DOOR OPENING TRIM LH
- INSTALL REAR DOOR OPENING TRIM RH
- INSTALL REAR DOOR SCUFF PLATE LH
- INSTALL REAR DOOR SCUFF PLATE RH