LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2006 >> Matrix Base, FWD, Standard >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior >> Roof Headlining >> Removal

Roof Headlining: Removal

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See SPECIFIED TORQUE FOR STANDARD BOLTS ).

  1. REMOVE FRONT DOOR SCUFF PLATE LH 
    1. Using a screwdriver, remove the scuff plate.

      HINT:

      Tape the screwdriver tip before use.

  2. REMOVE FRONT DOOR SCUFF PLATE RH 

    HINT:

    Use the same procedures described for the LH side.

    Fig 1: Removing Scuff Plate
    G04467046Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE COWL SIDE TRIM BOARD LH 
    1. Remove the clip labeled A.
    2. Using a screwdriver, disengage the 2 clips labeled B and remove the trim board.

      HINT:

      Tape the screwdriver tip before use.

    3. Fig 2: Removing Cowl Side Trim Board LH
      G04467047Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE COWL SIDE TRIM BOARD RH 

    HINT:

    Use the same procedures described for the LH side.

  5. REMOVE REAR DOOR SCUFF PLATE LH 
    1. Using a screwdriver, remove the scuff plate.

      HINT:

      Tape the screwdriver tip before use.

  6. Fig 3: Removing Rear Door Scuff Plate
    G04467048Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE REAR DOOR SCUFF PLATE RH 

    HINT:

    Use the same procedures described for the LH side.

  8. REMOVE FRONT DOOR OPENING TRIM LH 
  9. REMOVE FRONT DOOR OPENING TRIM RH 
  10. REMOVE REAR DOOR OPENING TRIM LH 
  11. REMOVE REAR DOOR OPENING TRIM RH 
  12. REMOVE CENTER PILLAR LOWER GARNISH LH 
    1. Using a screwdriver, pull the garnish lower upward to remove it.

      HINT:

      Tape the screwdriver tip before use.

  13. Fig 4: Removing Center Pillar Lower Garnish
    G04467049Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE CENTER PILLAR LOWER GARNISH RH 

    HINT:

    Use the same procedures described for the LH side.

  15. REMOVE CENTER PILLAR GARNISH LH 
    1. Using a screwdriver, remove the shoulder anchor cover cap.

      HINT:

      Tape the screwdriver tip before use.

    2. Fig 5: Removing Shoulder Anchor Cover Cap
      G04467050Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt and disconnect the front seat outer belt (shoulder anchor side).
    4. Remove the bolt and disconnect the front seat outer belt (floor anchor side).
    5. Using a screwdriver, remove the pillar garnish.

      HINT:

      Tape the screwdriver tip before use.

      Fig 6: Removing Pillar Garnish
      G04467051Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE CENTER PILLAR GARNISH RH 

    HINT:

    Use the same procedures described for the LH side.

  17. REMOVE NO. 2 DECK BOARD 
  18. REMOVE DECK BOARD SUB-ASSEMBLY 
    1. Remove the 2 bolts and deck board.
      Fig 7: Removing Bolts And Deck Board
      G04467052Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  19. REMOVE REAR DECK FLOOR BOX 
    1. Loosening the spare wheel carrier and remove the deck floor box rear.
      Fig 8: Loosening Spare Wheel Carrier
      G04467053Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  20. REMOVE LUGGAGE COMPARTMENT TRAY 
    1. Remove the 5 bolts and luggage compartment tray.
    2. Fig 9: Removing Bolts And Luggage Compartment Tray
      G04467054Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  21. REMOVE BACK DOOR WEATHERSTRIP 
  22. REMOVE REAR DECK TRIM COVER 
    1. Remove the 2 clips.
    2. Using a moulding remover, remove the deck trim cover rear.
  23. REMOVE TONNEAU COVER ASSEMBLY 
  24. REMOVE REAR SEAT CUSHION ASSEMBLY 

    HINT:

    See REMOVAL

  25. REMOVE REAR SEATBACK ASSEMBLY 

    HINT:

    See REMOVAL

  26. REMOVE REAR SEAT SIDE GARNISH LH 
    1. Remove the bolt and seat back hinges.
    2. Using a screwdriver, remove the side garnish.

      HINT:

      Tape the screwdriver tip before use.

  27. Fig 10: Removing Rear Seat Side Garnish
    G04467056Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  28. REMOVE REAR SEAT SIDE GARNISH RH 

    HINT:

    Use the same procedures described for the LH side.

  29. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH 
    1. Remove the 4 bolt and 4 rope hooks.
    2. Using a screwdriver, disengage the 3 claws and 3 clips, and remove the side panel.

      HINT:

      Tape the screwdriver tip before use.

  30. Fig 11: Removing Deck Trim Side Panel Assembly
    G04467057Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  31. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH 

    HINT:

    Use the same procedures described for the LH side.

  32. REMOVE ROOF SIDE GARNISH INNER LH 
    1. Using a screwdriver, remove the seat belt anchor cover.

      HINT:

      Tape the screwdriver tip before use.

    2. Fig 12: Using Screwdriver To Remove Seat Belt Anchor Cover
      G04467058Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt and rear seat 3-point belt.
    4. Using a screwdriver, remove the roof side garnish.

      HINT:

      Tape the screwdriver tip before use.

  33. Fig 13: Removing Roof Side Garnish Inner
    G04467059Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  34. REMOVE ROOF SIDE GARNISH INNER RH 

    HINT:

    Use the same procedures described for the LH side.

  35. REMOVE FRONT PILLAR GARNISH LH 
    1. Using a screwdriver, remove the pillar garnish.

      HINT:

      Tape the screwdriver tip before use.

  36. Fig 14: Removing Pillar Garnish
    G04467060Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  37. REMOVE FRONT PILLAR GARNISH RH 

    HINT:

    Use the same procedures described for the LH side.

  38. REMOVE VISOR ASSEMBLY LH 
    1. Remove the 2 screws and visor.
  39. Fig 15: Removing Visor Assembly
    G04467061Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  40. REMOVE VISOR ASSEMBLY RH 
    1. Remove the 2 screws and visor.
  41. REMOVE MAP LIGHT ASSEMBLY 
    1. Remove the screw.
    2. Using a screwdriver, disengage the 4 clips and remove the light lens and cover.

      HINT:

      Tape the screwdriver tip before use.

      Fig 16: Disengaging Clips And Removing Light Lens And Cover
      G04467062Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the screw.
    4. Using a screwdriver, remove the map light.

      HINT:

      Tape the screwdriver tip before use.

  42. REMOVE NO. 1 INTERIOR LIGHT ASSEMBLY 
    1. Using a screwdriver, remove the lens cover.
    2. Using a screwdriver, remove the room light, as shown in the illustration.

      HINT:

      Tape the screwdriver tip before use.

      Fig 17: Removing Room Light Using Screwdriver
      G04467063Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  43. REMOVE ASSIST GRIP SUB-ASSEMBLY 
    1. Using a screwdriver, remove the 2 grip covers.
    2. Fig 18: Removing Grip Covers Using Screwdriver
      G04467064Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 2 screws and assist grip.

      HINT:

      Tape the screwdriver tip before use.

  44. REMOVE VISOR HOLDER 
    1. Remove the visor holder by turning it 90° counterclockwise.
    2. Fig 19: Removing Visor Holder By Turning It 90° Counterclockwise
      G04467065Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  45. REMOVE SUN ROOF OPENING TRIM MOULDING (w/SLIDING ROOF) 
  46. REMOVE ROOF HEADLINING ASSEMBLY 
    1. Remove the 2 clips and roof headlining.
    2. Fig 20: Removing Clips And Roof Headlining
      G04467066Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the wire harness.