LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2006 >> Matrix Base, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (1ZZ-FE) - SFI System - Component Tests >> THROTTLE BODY (for 4WD) >> Inspection

THROTTLE BODY (for 4WD): Inspection

  1. INSPECT THROTTLE BODY ASSEMBLY 
    1. Check the throttle body.
      1. Check that the throttle valve shaft is not rickety.
      2. Check that all ports are not clogged.
      3. Check that the throttle valve opens and closes smoothly.
        Fig 1: Inspecting Throttle Body Assembly
        G04460476Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. Check that there is no clearance between the throttle stop screw and throttle lever at the throttle valve closed position.
        NOTE: Do not touch the throttle stop screw.
  2. INSPECT E.F.I. THROTTLE POSITION SENSOR 
    1. Check the resistance.
      1. Disconnect the throttle position sensor connector.
      2. Using an ohmmeter, measure the resistance between terminals VC and E2.

        Resistance: 2.5 to 6.0 k 

      3. Check the resistance variation between terminals VTA and E2.

        Variation of resistance: The resistance value increases in proportion to the throttle lever opening value. 

        HINT:

        Fig 2: Inspecting E.F.I. Throttle Position Sensor
        G04460477Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        THROTTLE VALVE MOVEMENT - RESISTANCE

        Throttle valve Movement Resistance
        Fully close 0.2 to 5.7 k
        Fully open 2.0 to 10.2 k

        If the result is not as specified, replace the E.F.I. throttle position sensor.