LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. Inspect seat memory switch. 

    PREPARATION: 

    Disconnect the Seat Memory Switch Connector.

    CHECK: 

    Measure the resistance of each terminal, as shown in the illustration and table.

    OK: 

    TESTER CONNECTION SPECIFIED CONDITION CHART

    Tester Connection Switch Position Specified Condition
    1 - 4 SET switch OFF --> ON 10 k Ω or higher--> Below 1 Ω
    2 - 4 Memory switch 1 OFF --> ON 10 k Ω or higher --> Below 1 Ω
    3 - 4 Memory switch 2 OFF --> ON 10 k Ω or higher--> Below 1 Ω
    Fig 1: Identifying Seat Memory Switch Connector
    G03059697Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: Replace Seat Memory Switch. 
    2. OK: Go to next step. 
  2. Check Harness and Connector (Body ECU & Seat Memory Switch - Body Ground). 

    PREPARATION: 

    1. Reconnect the Seat Memory Switch Connector.
    2. Disconnect the B6 body ECU Connector.

      CHECK: 

      Measure the resistance of each terminal, as shown in the illustration and table.

      OK: 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection (Symbol) Switch Position Specified Condition
      B6-23 (M1) - Body ground Memory switch 1 OFF --> ON 10 k Ω or higher--> Below 1 Ω
      B6-24 (MM) - Body ground SET switch OFF --> ON 10 k Ω or higher --> Below 1 Ω
      B6-22 (M2) - Body ground Memory switch 2 OFF --> ON 10 k Ω or higher --> Below 1 Ω
      Fig 2: Disconnecting B6 Body ECU Connector
      G03059698Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: Repair or replace Harness or Connector. 
    2. OK: Proceed to next Circuit Inspection shown in Problem Symptoms Table (See  PROBLEM SYMPTOMS TABLE  ).