LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. Check fuse (PWR SEAT, ECU-IG, AM1). 

    PREPARATION: 

    Remove the PWR SEAT, ECU-IG and AM1 fuses from the Instrument Panel J/B.

    CHECK: 

    Measure the resistance.

    OK: 

    Below 1 Ω 

    1. NG: Replace fuse. 
    2. OK: Go to next step. 
  2. Inspect Position Control ECU & Switch Assy. 

    PREPARATION: 

    Disconnect the M6 and M7 ECU connectors.

    CHECK: 

    1. Measure the voltage of each terminal of the Wire Harness Side Connectors.
      Fig 1: Identifying M6 And M7 ECU Connectors
      G03059695Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK: 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection (Symbol) Condition Specified Condition
      M7-5 (+B) - Body ground Always 10 to 14 V
      M6-8 (SYSB) - Body ground Always 10 to 14 V
      M6-4 (IG) - Body ground Ignition switch OFF --> ON Below 1 V--> 10 to 14 V
    2. Measure the resistance between the M7 ECU wire harness side connector and body ground.

      OK: 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection (Symbol) Specified Condition
      M7-1 (GND) - Body ground Below 1 Ω
    1. NG: Repair or replace Harness or Connector. 
    2. OK: Proceed to next Circuit Inspection shown in Problem Symptoms Table (See  PROBLEM SYMPTOMS TABLE  ).