LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Sequoia SR5, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System - Diagnostics >> Circuit Inspection >> Control Switch Circuit (Cruise Control Switch) >> Inspection Procedure

Inspection Procedure

  1. Check voltage between terminals CCS of ECM connector and body ground. 

    PREPARATION: 

    1. Remove the ECM with connector still connected.
    2. Turn ignition switch ON.

    CHECK: 

    Measure voltage between terminals CCS of ECM connector and body ground when each of the -/SET, +/RES and CANCEL is turned ON.

    CONTROL SWITCH VOLTAGE SPECIFICATIONS

    Switch position Voltage (V)
    Neutral 9 - 14 V
    +/RES 2.1 - 4 V
    -/SET 4 - 7.1 V
    CANCEL 6 - 10.1 V
    Fig 1: Measuring Voltage Between Terminal CSC Of ECM Connector And Ground
    G02921898Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: Proceed to next circuit inspection shown in problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ). 
    2. OK: Go to next step. 
  2. Check cruise control switch continuity. 

    PREPARATION: 

    1. Remove steering wheel center pad.
    2. Disconnect the cruise control switch connector.

    CHECK: 

    1. Measure resistance between terminal 4 and 5 of the cruise control switch connector when control switch is operated.

      OK: 

      CONTROL SWITCH RESISTANCE SPECIFICATIONS

      Switch position Resistance (Ω)
      Neutral (No continuity)
      +/RES 210 - 270
      -/SET 560 - 700
      CANCEL 1380 - 1700
      Fig 2: Measuring Resistance Between Control Switch Terminals 4 And 5
      G02921899Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check continuity between terminals 4 and 5 of control switch connector when main switch is held on and off.

      OK: 

      CONTROL SWITCH CONTINUITY SPECIFICATIONS

      Switch position Tester connection Specified condition
      OFF 4 - 5 No continuity
      ON 4 - 5 Continuity
    1. NG: Replace control switch. 
    2. OK: Go to next step. 
  3. Check harness and connector between ECM and cruise control switch, cruise control switch and body ground (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
    1. NG: Repair or replace harness or connector. 
    2. OK: Go to next step. 
  4. Check cruise control indicator light (See combination meter). 
    1. NG: Replace combination meter. 
    2. OK: Check and replace ECM (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ).