LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission O.D Direct Clutch Speed Sensor >> On-Vehicle Repair

On-Vehicle Repair

  1. DISCONNECT O/D DIRECT CLUTCH SPEED SENSOR CONNECTOR 
  2. REMOVE O/D DIRECT CLUTCH SPEED SENSOR 
    1. Remove the bolt and O/D direct clutch speed sensor.
    2. Remove the O-ring from the O/D direct clutch speed sensor.
      Fig 1: Disconnecting O/D Direct Clutch Speed Sensor Connector
      G02851630Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL O/D DIRECT CLUTCH SPEED SENSOR 
    1. Coat a new O-ring with ATF and install it to the O/D direct clutch speed sensor.
    2. Install the O/D direct clutch speed sensor to the transmission case with the bolt.

      Torque: 5.4 N.m (55 Kgf.cm, 48 in.lbf) 

  4. CONNECT O/D DIRECT CLUTCH SPEED SENSOR CONNECTOR