LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> Sequoia SR5, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 380 (Stop Light System) >> Inspection

Section 380 (Stop Light System): Inspection

WARNING: This page is about a different car, the 2004 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT STOP LIGHT SWITCH CONTINUITY 
    STOP LIGHT SWITCH CONTINUITY

    Switch Position Tester Connection Specified Condition
    Switch Pin Free 1 - 4 Continuity
    Switch Pin Pushed In 1 - 4 No Continuity
    Switch Pin Free 2 - 3 No Continuity
    Switch Pin Pushed In 2 - 3 Continuity

    If continuity is not as specified, replace the switch.

    Fig 1: Identifying Stop Light Switch
    G02928003Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. w/ Rear Spoiler: 
    1. INSPECT HI- MOUNTED STOP LIGHT ASSEMBLY CONTINUITY 

    Using the ohmmeter, check that continuity exists between terminal 1 and terminal 2.

    If continuity is not as specified, replace the light assembly or bulb.

    Fig 2: Identifying HI-Mounted Stop Light Assembly
    G02928004Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. w/o Rear Spoiler: 
    1. INSPECT HI- MOUNTED STOP LIGHT ASSEMBLY CONTINUITY 

    Using the ohmmeter, check that continuity exists between terminal 1 and terminal 2.

    If continuity is not as specified, replace the light assembly or bulb.

    Fig 3: Identifying Hi - Mounted Stop Light Assembly Connector Terminal
    G02928005Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002