Registration Procedure
- KEY REGISTRATION IN AUTOMATIC REGISTRATION MODE
- Registration of a new transponder key.NOTE:
- This procedure must be done when you install a new Transponder key ECU.
- The new Transponder key ECU is on the automatic key code registration mode. The already fixed number of key codes for this Transponder key ECU can be registered
- On this type of vehicle, up to 3 key codes can be registered.
- In the automatic registration mode, the last key registered becomes sub-key.
NOTE:- When a key cannot be inserted in the key cylinder on the automatic registration mode, the security indicator always comes on.
- When the immobilizer system operates normally and the key is pull out, the security indicator blinks.
- When key code registration could not be performed on the automatic registration mode, code 2-1 is output from the security indicator and when the registered key in inserted, code 2-2 is output.
- Automatic registration mode completion
- If completing the mode forcibly when more than 1 keys code are registered on the automatic registration mode, perform the following procedures.
- After 1 more key code is registered with master key, turn the ignition switch LOCK -> ON 5 times within 10 secs. by inserting the registered key or without pulling the key out.
- Registration of a new transponder key.
- REGISTRATION OF ADDITIONAL MASTER KEY AND SUB KEY
Do this operation to register an additional master key and sub key.
*1: Insert master key into the key cylinder.
Turn the ignition switch to LOCK -> ON position 5 times within 15 seconds.
*2: Open -> Close the driver's door 6 times within 20 seconds after completion of the previous operation.
*3: Remove the master key from the ignition switch and insert another key to be registered in the key cylinder within 10 seconds after completion of the previous operation.
*4: Turn the ignition switch to ON position and wait for 60 seconds or more. The key registration will be completed.
*5: Ten seconds or more elapses after removal of the key or Open -> Close the driver's door, key registration completed.
*6: When registering multiple keys, insert the key to be registered in the key cylinder.
NOTE:- It is possible to register up to 4 master key codes including the registered key code.
- It is possible to register up to 2 sub key codes including the register key code.
- When any operation time described below is over, registration mode completes.
- When the next procedure is performed while the timer is working, the timer completes counting time, then next timer starts.
- ERASURE OF TRANSPONDER KEY CODE
Do this operation to erase transponder key registration from the transponder key computer.
NOTE: Delete all other master and sub-key codes leaving the master key code to use the operation. When using the key which was used before deletion, it is necessary to register the code again.*1: Insert master cylinder into the key cylinder.
Turn the ignition switch to LOCK -> ON 6 times within 15 seconds.
*2: Open -> Close driver's door 7 times and remove the master key within 20 seconds after completion of the previous operation.
NOTE:- When any operation time described below is over, registration mode completes.
- When the next procedure is performed while the timer is working, the timer completes counting time, then next timer starts.
- ECU COMMUNICATION ID REGISTRATION NOTE:
- The ECU communication ID should be registered when the transponder key ECU and/or the ECM is replaced, in order to match these ECM COMMUNICATION ID.
- The engine cannot be started unless the ECM COMMUNICATION ID matches.
- Register the ECU communication ID.
- After the transponder key ECU and/or the ECM is replaced, turn the ignition switch ON (the engine is not running).
- Short the TC and CG terminals of the DLC3 and leave it as is for 30 minutes.
- Check that the engine starts.