Inspection Procedure
- Are there any other codes (besides DTC P3060) being output?
YES: Go to relevant DTC chart.
NO: Go to next step
- Check resistance of battery temperature sensor.
PREPARATION:
- Remove the battery cover (See HV BATTERY ).
- Disconnect the battery temperature sensor connector.
CHECK:
Using an ohmmeter, measure the resistance between terminals.
OK:
Standard resistance:
BATTERY TEMPERATURE SENSOR RESISTANCE SPECIFICATIONSTerminals Resistance (at 25°C (77°F) 1 - 2 9 - 11 kΩ 3 - 4 9 - 11 kΩ 5 - 6 9 - 11 kΩ 7 - 8 9 - 11 kΩ 9 - 10 9 - 11 kΩ NG: Replace the battery temperature sensor.
OK: Check fitting of battery temperature sensor connector and correct if necessary.