LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> Prius >> Repair and Diagnosis >> Electrical >> Charging Systems >> HV Battery Control System - Diagnostics >> Circuit Inspection >> DTC P1600: Back Up Power Source Circuit Malfunction >> Inspection Procedure

Inspection Procedure

NOTE:

Read freeze frame data using a TOYOTA hand-held tester or OBD II scan tool. Because freeze frame data records the battery condition when the malfunction is detected. When troubleshooting, this is useful for knowing the battery condition.

  1. Check voltage between terminal AM of Battery ECU connector and body ground. 

    PREPARATION: 

    Remove the luggage trim.

    CHECK: 

    Measure the voltage between terminal AM of the Battery ECU connector and body ground.

    Fig 1: Measuring AM Terminal Voltage At Battery ECU Connector
    G02829904Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    OK: 

    Voltage: 9 - 14 V 

    OK: Check and replace Battery ECU (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 

    NG: Go to next step 

  2. Check HV fuse of engine room J/B. 

    PREPARATION: 

    Remove the HV fuse from the engine room J/B.

    Fig 2: Locating HV Fuse (Engine Room J/B)
    G02829905Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    CHECK: 

    Check the continuity of the HV fuse.

    OK: 

    Continuity 

    NG: Check for short in all harness and components connected to HV fuse. 

    OK: Check and repair harness or connector between battery and HV fuse, and HV fuse and Battery ECU (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ).