LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> ECHO 4D Sedan, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Shift Interlock Systems >> Removal & Installation >> Floor Shift Assembly >> Reassembly

Floor Shift Assembly: Reassembly

  1. Install spring and shift lock release button. See Figure.
  2. Install shift lever sub-assembly as follows:
    1. Apply MP grease on the control shaft, shift lever sub-assembly, grooved pin, spring and detent rod.
    2. Install the shift lever sub-assembly and control shaft to the shift lever plate.
    3. Install the spring and detent rod.
    4. Using a punch and hammer, install the grooved pin to the detent rod pin hole so dimension "A" = 1.161 +/- 0.020 in. (29.5 +/- 0.5 mm). See Fig 1.
    5. Check the detent rod operation.
    Fig 1: Installing Groved Pin To Detent Rod
    G00251804Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. Install shift lock solenoid rod.
  4. Install key interlock cable rod. See Figure.
  5. Install indicator light wire. See Figure.
  6. Install shift lock unit as follows:
    1. Install the solenoid. See Figure.
    2. Install the shift lock unit with the screw. See Figure.
  7. Install position indicator housing as follows:
    1. Install the position indicator plate to the position indicator housing. See Figure.
    2. Install the position indicator slide cover to the shift lever plate.
    3. Install the position indicator housing to the shift lever plate.
    4. Install the cover to the position indicator housing.
  8. Install shift lever knob sub-assembly as follows:
    1. Apply MP grease on the shift lever knob button and spring.
    2. Install the O/D main switch. See Figure.
    3. Install the spring and shift lever knob button.
    4. Install the shift lever knob cover.
    5. Install the shift lever sub-assembly with the 2 screws. Coat the threads of screws with Sealant (08833-00080, THREE BOND 1344, LOCTITE 242) or equivalent.
      NOTE: Make sure not to catch O/D main swatch wire harness.
    6. Clamp the wire harness to the shift lever plate. See Figure.
  9. Install O/D main switch terminal. See Figure.