LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> ECHO 4D Sedan, Automatic >> Repair and Diagnosis >> Steering >> Tilt Steering Column >> Removal

Tilt Steering Column: Removal

  1. REMOVE STEERING WHEEL PAD 
    NOTE: If the airbag connector is disconnected with the ignition switch at ON, DTCs will be recorded.
    1. Place the front wheels facing straight ahead.
    2. Using a torx socket wrench, loosen the 2 torx screws until the groove along the screw circumference catches on the screw case.
      Fig 1: Removing Steering Wheel Pad
      G02826516Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pull out the wheel pad from the steering wheel and disconnect the airbag connector.
    4. Disconnect the connector.
    CAUTION:
    • When storing the wheel pad, keep the upper surface of the pad facing upward.
    • Never disassemble the wheel pad.
    NOTE: When removing the wheel pad, take care not to pull the airbag wire harness.
    Fig 2: Disconnecting Airbag Connector
    G02826517Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE STEERING WHEEL 
    1. Remove the steering wheel set nut.
    2. Place matchmarks on the steering wheel and main shaft assembly.
    3. Using SST, remove the steering wheel.

    SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    Fig 3: Removing Steering Wheel
    G02826518Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE COLUMN LOWER COVER 

    Remove the 3 screws and column lower cover.

  4. REMOVE SPIRAL CABLE, LIGHT CONTROL SWITCH AND HEADLIGHT DIMMER SWITCH, WIPER AND WASHER SWITCH AND COLUMN UPPER COVER 
    1. Disconnect the 3 connectors from the spiral cable, light control switch and headlight dimmer switch and wiper and washer switch.
    2. Disconnect the airbag connector from the spiral cable.
    3. Push the claw and pull out the light control switch and headlight dimmer switch.
    4. Employ the same manner described above to the wiper and washer switch.
      Fig 4: Removing Light Control Switch And Head Light Dimmer Switch
      G02826519Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Slide the column upper cover and remove the spiral cable.
      NOTE: Do not disassemble the spiral cable or apply oil to it.
    6. Remove the column upper cover.
    7. Fig 5: Removing Column Upper Cover
      G02826520Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. A/T: 

    REMOVE KEY INTERLOCK CABLE (See  REMOVAL  ) 

  6. REMOVE NO. 2 COLUMN HOLE COVER 

    Remove the clip and No. 2 column hole cover.

  7. DISCONNECT SLIDING YOKE 
    1. Place matchmarks on the sliding yoke and No. 3 intermediate shaft assembly.
    2. Loosen the bolt A and remove the bolt B, then disconnect the sliding yoke.
    3. Fig 6: Matchmarking Sliding Yoke And Intermediate Shaft Assembly
      G02826521Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE STEERING COLUMN ASSEMBLY 
    1. Disconnect the connectors.
    2. Remove the lower mount bolt, 2 upper mount bolts and steering column assembly.
  9. REMOVE SLIDING YOKE 

    Remove the bolt A and sliding yoke.

  10. REMOVE NO. 2 INTERMEDIATE SHAFT ASSEMBLY 
    1. Place matchmarks on the No. 2 intermediate shaft assembly and main shaft assembly.
    2. Remove the bolt and No. 2 intermediate shaft assembly.
      Fig 7: Matchmarking Intermediate Shaft And Main Shaft Assembly
      G02826522Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002