Section 487 (Interior Light System): Inspection
WARNING: This page is about a different car, the 2004 Toyota ECHO. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT ROOM LIGHT CONTINUITY
- Disconnect the connector from the room light.
- Turn the room light switch ON, and check that there is continuity between terminal 2 and body ground.
- Turn the room light switch DOOR, and check that there is continuity between terminals 1 and 2.
If continuity is not as specified, replace the light assembly or bulb.
- INSPECT DOOR COURTESY SWITCH CONTINUITY
- Check that continuity exists between terminals and the switch body with the switch ON (switch pin released: opened door).
- Check that no continuity exists between terminals and the switch body with the switch OFF (switch pin pushed in: closed doors).
If operation is not as specified, replace the switch.
- INSPECT LUGGAGE COMPARTMENT DOOR COURTESY SWITCH CONTINUITY
- Check that continuity exists between terminals and the switch body with the switch ON (switch pin released: opened door).
- Check that no continuity exists between terminals and the switch body with the switch OFF (switch pin pushed in: closed doors).
If operation is not as specified, replace the switch.
- INSPECT LUGGAGE COMPARTMENT LIGHT CONTINUITY
Using the ohmmeter, check that there is continuity between terminals.
If continuity is not as specified, replace the light assembly or bulb.
- INSPECT LICENCE PLATE LIGHT CONTINUITY
Using the ohmmeter, check that continuity exists between terminals.
If continuity is not as specified, replace the light assembly or bulb.