LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> ECHO 4D Sedan, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self Diagnostics >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes >> CHECK Mode Code Retrieval (Toyota Hand-Held Tester Only)

CHECK Mode Code Retrieval (Toyota Hand-Held Tester Only)

NOTE: Compared to normal mode, check mode has an increased sensitivity to detect malfunctions. Furthermore, same diagnostic items which are detected in normal mode can also be detected in check mode.
  1. Ensure vehicle battery voltage is 11 V or more. Apply parking brake. Place transaxle in Neutral (M/T) or Park (A/T). Ensure A/C and ignition are off. Check that throttle valve is fully closed.
  2. Prepare and connect hand-held tester to DLC3 under instrument panel lower pad. See Figure. Turn ignition switch ON and then turn hand-held tester ON.
  3. Switch hand-held tester from normal mode to check mode. Ensure malfunction indicator light (MIL) on instrument cluster flashes.
    NOTE: If hand-held tester switches ECM from normal mode to check mode or vice-versa, or if ignition switch is turned from ON to ACC or LOCK during check mode, DTCs and freeze frame data will be erased.
  4. Start engine and allow engine to idle. If no DTCs are present, MIL will turn off. Try to simulate conditions of driveability complaint described by customer.
    NOTE: Leave ignition switch ON until you have checked DTC, etc.
  5. After simulating malfunction conditions, use hand-held tester diagnosis selector to check DTCs and freeze frame data, etc. For information on freeze frame data, see FREEZE FRAME DATA . If driveability problem exists and no DTCs are present, go to TROUBLE SHOOTING - NO CODES article for diagnosis by symptom.
    NOTE: Take care not to turn ignition switch OFF. Turning ignition switch OFF switches diagnosis system from check mode to normal mode. So all DTCs, etc. are erased.
  6. If any DTCs are present, perform appropriate DTC test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .
  7. After repairs for DTC have been completed, DTC must be cleared from ECM. See CLEARING DIAGNOSTIC TROUBLE CODES . Road test vehicle to ensure all symptoms and/or complaints have been repaired.