Clearing Diagnostic Trouble Codes
NOTE:
If hand-held tester switches ECM from normal mode to check mode or vice-versa, or if ignition switch is turned from ON to ACC or OFF during check mode, DTCs and freeze frame data will be erased.
The DTCs and freeze frame data will be erased by either of following actions:
- Operating hand-held tester or OBD II scan tool (complying with SAE J1978) to erase codes. See OBD II scan tool's instruction book for operating instructions.
- Disconnecting battery terminals or EFI (15-amp) fuse located in engine room junction block, for about 1 minute. However, other various memory functions such as clock, radio, alarm, seats, etc. will be cleared and must be reset.