LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> ECHO 4D Sedan, Automatic >> Repair and Diagnosis >> Body & Frame >> Windows >> Quarter Window Glass >> Removal

Quarter Window Glass: Removal

  1. REMOVE FRONT DOOR SCUFF PLATE 

    Insert a screwdriver between the front door scuff plate and body to pry it out.

    HINT:

    Tape the screwdriver tip before use.

    Fig 1: Identifying Front Door Scuff Plate
    G02826230Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE FRONT DOOR OPENING TRIMS 

    Remove the front door opening trims except cowl side trim parts.

  3. REMOVE REAR SEAT CUSHION (See  REMOVAL  or  REMOVAL  ) 
  4. REMOVE REAR SEATBACK (See  REMOVAL  or  REMOVAL  ) 
  5. REMOVE QUARTER TRIM 
    1. Remove the bolt and rear seat outer belt floor anchor.
    2. w/ Split type rear seat:

      Remove the bolt and rear seatback hinge.

    3. Insert a screwdriver between the quarter trim and body to pry it out.

    HINT:

    Tape the screwdriver tip before use.

    Fig 2: Removing Bolts And Rear Seat Outer Belt Floor Anchor
    G02826231Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FRONT PILLAR GARNISH 

    Using a screwdriver, remove the front pillar garnish.

    HINT:

    Tape the screwdriver tip before use.

    Fig 3: Identifying Pillar Garnish
    G02826232Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE ROOF SIDE INNER GARNISH 
    1. Using a screwdriver, open the seat belt shoulder anchor cover cap.

      HINT:

      Tape the screwdriver tip before use.

    2. Remove the bolt and front seat outer belt shoulder anchor.
      Fig 4: Opening Seat Belt Shoulder Anchor Cover Cap
      G02826233Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the clip.
    4. Insert a screwdriver between the roof side inner garnish and body to pry it out.
    5. Fig 5: Removing Roof Side Inner Garnish
      G02826234Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    HINT:

    Tape the screwdriver tip before use.

  8. REMOVE ASSIST GRIP 
    1. Using a screwdriver, open the caps.

      HINT:

      Tape the screwdriver tip before use.

    2. Remove the 2 screws.
    3. Remove the assist grip.
  9. REMOVE QUARTER WINDOW GLASS 
    1. Push a piano wire through from the interior.
    2. Tie both wire ends to wooden blocks or similar objects.

      HINT:

      Apply protective tape to the outer surface to keep the surface from being scratched.

      NOTE: When separating the glass, take care not to damage the paint and exterior.
      Fig 6: Using Protective Tape
      G02826235Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Cut the adhesive by pulling the piano wire around it.

      HINT:

      Cut the adhesive areas as shown in the illustration, leaving the adhesive where the spacers are.

      Fig 7: Cutting The Adhesive
      G02826236Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Push the piano wire through as shown in the illustration, cut off the adhered part to the clips.
    5. Fig 8: Locating Rear Door Glass
      G02826237Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Remove the glass.
    NOTE: Leave as much of the adhesive on the body as possible when cutting off the glass.