LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> ECHO 2D Sedan, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 479 (Automatic Transmission System) >> ATF Temperature Sensor >> On-Vehicle Repair

On-Vehicle Repair

WARNING: This page is about a different car, the 2004 Toyota ECHO. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT SOLENOID CONNECTOR 
  2. REMOVE LH ENGINE UNDER COVER 
    Fig 1: Disconnecting Solenoid Connector
    G02906446Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE DRAIN PLUG AND DRAIN ATF 
  4. REMOVE OIL PAN AND GASKET 
    NOTE: Some fluid will remain in the oil pan.

    Remove the 19 bolts, and carefully remove the oil pan assembly. Discard the gasket.

    Fig 2: Removing Oil Pan
    G02906447Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE OIL STRAINER 
    1. Remove the 3 bolts and oil strainer.
    2. Remove the O-ring.
      Fig 3: Removing Oil Strainer
      G02906448Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. DISCONNECT 5 SHIFT SOLENOID VALVE CONNECTORS 
  7. REMOVE ATF TEMPERATURE SENSOR 
    1. Remove the bolt and lock plate, and remove the ATF temperature sensor.
    2. Remove the O-ring from the ATF temperature sensor.
  8. INSTALL ATF TEMPERATURE SENSOR 
    1. Coat a new O-ring with ATF and it to the direct clutch speed sensor.
    2. Install the ATF temperature sensor with the lock plate and bolt.

      Torque: 11 N.m (110 kgf.cm, 8 ft.lbf) 

      Fig 4: Installing ATF Temperature Sensor
      G02906449Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. CONNECT 5 SHIFT SOLENOID VALVE CONNECTORS 
  10. INSTALL OIL STRAINER 
    1. Coat a new O-ring with ATF.
    2. Install the O-ring to the oil strainer.
      Fig 5: Installing O-Ring To Oil Strainer
      G02906450Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the oil strainer with the 3 bolts.

      Torque: 11 N.m (110 kgf.cm, 8 ft.lbf) 

      Fig 6: Installing Oil Strainer
      G02906451Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. INSTALL OIL PAN 

    Install the oil pan and a new gasket with the 19 bolts.

    Torque: 7.8 N.m (80 kgf.cm, 69 in.-lbf) 

  12. Fig 7: Installing Oil Pan
    G02906452Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  13. INSTALL DRAIN PLUG 

    Install a new gasket and drain plug.

    Torque: 49 N.m (500 kgf.cm, 36 ft.lbf) 

  14. CONNECT SOLENOID CONNECTOR 
  15. Fig 8: Connecting Solenoid Connector
    G02906453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. FILL ATF AND CHECK ATF LEVEL (See  PRE-CHECK  ) 
  17. INSTALL LH ENGINE UNDER COVER