Removal & Installation: Notes
NOTE:
Manufacturer recommends removing right axle shaft and intermediate shaft (if equipped) as an assembly.
- Raise and support vehicle.
- Remove front wheels.
- Drain transaxle fluid into proper container.
- Loosen axle shaft bearing lock nut. Apply brakes, and remove axle shaft bearing lock nut.
- Disconnect steering knuckle from lower control arm. See Fig 1.
- Remove nut, and disconnect tie rod end from steering knuckle.
- Separate axle shaft from steering knuckle. Using a plastic hammer, disconnect axle shaft from axle hub.
- Using a hub nut wrench and hammer handle, pull out axle shaft.