LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2002 >> Land Cruiser >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Systems - Diagnostics >> Circuit Inspection >> Rear Wiper Motor & Relay Circuit >> Inspection Procedure

Inspection Procedure

  1. Check WIPER fuse 

    Check continuity of WIPER fuse.

    OK: Continuity 

    1. OK: Go to next step.
    2. NG: Replace the failure fuse.

  2. Check voltage between terminals WRRY, WLRY and GND of Body ECU connector. 

    Turn ignition switch ON.

    Measure voltage between terminals WRRY, WLRY, and GND.

    OK: Voltage: 10 - 14V 

    1. OK: Proceed to next circuit inspection shown on problem symptoms table (See PROBLEM SYMPTOMS TABLE ).
    2. NG: Go to next step.

  3. Check rear wiper relay (See  INSPECTION  )  .
    1. OK: Go to next step.
    2. NG: Replace the rear wiper motor.
  4. Check rear wiper motor (See  INSPECTION  )  .
    1. OK: Go to next step.
    2. NG: Replace the rear wiper motor.
  5. Check wire harness and connector between rear wiper motor and Body ECU  .
    1. OK: Proceed to next circuit inspection shown on problem symptoms table (See PROBLEM SYMPTOMS TABLE ).
    2. NG: Repair or replace wire harness or connector.