Diagnostic Procedure
- Ensure stoplights illuminate when brake pedal is depressed, and turn off when released. If operation is as specified, go to next step. If operation is not as specified, repair stoplight circuit. See WIRING DIAGRAMS . Also, see appropriate article in ACCESSORIES & EQUIPMENT.
- Turn ignition off. Disconnect ABS actuator/ECU assembly harness connector. Using DVOM, check voltage between chassis ground and ABS actuator/ECU assembly harness connector terminal No. 5. See Figure. Depress brake pedal. If voltage reading is 8-14 volts, replace ABS actuator assembly. If voltage reading is not 8-14 volts, go to next step.
- Check for open in harness and connector between ABS actuator/ECU assembly and stoplight switch. Repair as necessary. If circuit is okay, perform next logical circuit check listed in symptom diagnosis. See SYMPTOM DIAGNOSIS under TROUBLE SHOOTING.