LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> RAV4 Base, AWD, Standard >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> OBD Monitor Drive Patterns >> Purpose of the Readiness Tests >> 7. EVAP Monitor (Engine RPM Monitor) >> Drive Pattern

Drive Pattern

  1. Connect the OBD II scan tool to the DLC3 to check monitor status and preconditions.
  2. Drive vehicle at 43 - 56 mph (70 - 90 km/h) for a period of 3 - 5 minutes.
    NOTE: Do not allow the Throttle Position (TP) to exceed 30 %.
    Drive with smooth throttle operation and avoid sudden acceleration.
  3. Stop vehicle and let engine idle for 3 - 5 minutes.
  4. Repeat steps "b" and "c" once.
  5. If readiness status does not switch to complete, ensure preconditions are met, turn ignition off, and then repeat steps "b" through "d".